Soooo, for the week I was suppose to learn how to do bias
binding(which I did) and learn a hemming technique for the bottom of my
McCalls 6559 dress(which unfortunately, I didn’t do).
I felt the length and the look of the dress would be a bit off by a
hem, so I’m going to try to get away without one, however, I did learn
how to use my own bias binding and I’m updating today with lots and lots
of pics and instructions on how I did it. Hopefully, it’s not too hard
to follow.
To start, the pics may be a little blurry since I only used my cell,
but I hope that you are able to see and understand. Also, I’m not the
best at the measurements, so bare with me if you can. Here is the
rundown using a sample.
BTW, Make sure you cut off the seam allowance around the neck and armhole edges before placing the binding. I actually lost the instructions to the dress, so I did everything basically my way. I marked off 1.5cm all around the edges, and cut it off.
- The first thing I did was fold the fabric at an angle to cut my bias
strips. In one of my sewing books the measurements of 2 3/4in(7cm) were
given, which was too big, but I followed the directions and cut out
about 6 strips.
- So after the strips were cut, I took out my pins, brought my strips
over to the ironing board, and folded one side of the strip so that it
measured 1cm. I placed the pins into the strips and through the ironing
board measuring 1cm down the length. With the other side of the strips I
just turned it over, and pinned it to the ironing board as well. When
both sides were pinned I ironed over the pins(maybe this isn’t the best
thing to do, but it worked for me) and took to pins out and ironed
again. It looked like this.
- After that was finished I folded the strips against the raw neck and
armhole edges of my dress(sample here) and pinned it in place with the
1cm side of the biased strip folded along the right side of the fabric.
- Then I used my sewing gauge and a water soluble pin to measure maybe
1/4cm(?) and make a dot at the mark on bias strip. *I’m not the best
with the measurements, so hopefully you all can see where I made the
mark.
- Then I went over to the sewing machine to top stitch and tried to
make sure the dot was right in between the middle of the presser foot.
Luckily, what helped me most is that the edge of the bias strip falls on
the first line on the needle plate(?) so that’s what my eyes followed
the entire time. Here’s the pics of that.
- I then adjusted the tension dials both to 3(instead of 4).
- And I sewed along the line, and this is the result of it on the sample and on the dress.
And that was it! I hope this helps in some way. I just started sewing
in January, so please bare with me in terms of the terminology,
measurements, pics etc. I like to read in books, but I also like to kind
of figure it out as I go, and do it in ways that appeal to me. For
example, the 1cm measurement I used to fold the bias strip along the
edge was from me taking the measurement on an edge of a shirt that I own
and using that, along with taking and using the measurement for the
stitching line. If there are any questions I’ll try to answer them to
the best of my ability.
Also, please excuse the chipped nail polish lol.
if the pics are too big, you can also view them at.
http://sewthankful.wordpress.com/2012/06/17/my-bias-binding-techniquelots-of-pics/
